Quote:
Originally Posted by vinrads
I would use car body filler ,sand flat ,then re paint the whole front ,with paint made for plastic , Mick.
|
Just a tip regarding removing the lettering slice off the melted plastic on the inside with a craft blade then push out each leg a bit at a time so as not to break the fixing pegs , the dial can be remover some come off easer than others , I use a bit of heat to loosen the glue or you could mask it off .make sure you de grease the part that you are painting, good luck with it , This is one I did some time ago it was very sun bleached so it needed painting not to every ones taste but I like it .Mick.