[ChristianFletcher]

Many thanks for the advice I’m still a bit confused regarding the wire size if that includes the enamel coating or not but it will become clear when my order arrives. When I measured the wire this included the coating. I will have to have another look at the website and check out how it’s specified.

On the bobbin I have marked the holes where the centre tap comes out and also where the winding finished. But I am going to try and count the wire off the core. Most of the turns are on the core first with possibly just the last third on the outside off the bobbin.

I will probably need a bit more advice before I’m finished so i will reports back with some pictures.

Thanks Regards Chris