View Single Post
Old 4th Oct 2010, 11:42 am   #16
bazzing
Retired Dormant Member
 
Join Date: Oct 2010
Location: Melbourne, Australia.
Posts: 3
Default Re: GEC Reliance Phone

The E-Link phone was developed in-house by RTC engineers. It utilised DC leg signalling and was connected using three wires. By sending positive or negative signals down the wires, all ten digits from 0 to 9 could be selected. It was used on strowger and cross-bar PAX systems (made in Hungary) and was their first PB telephone, modelled on an existing GEC/Telecom phone range.
The three wires mean it needed additional cabling. It was only used on internal (PAX) systems.

Thinking about this again, the E-Link was at least a step forward from the push-button phones on the market and available from Telecom. It did have some sort of electronic signalling. The push-button telephones available on the market were decadic, pressing a button sent a series of pulses in exactly the same way dial phones worked. Using them for long distance calls mean you had a long wait after keying in the numbers while the phone went through the the numbers and sent their pulses.
bazzing is offline