View Single Post
Old 21st Dec 2014, 11:43 pm   #1
Wendymott
Octode
 
Wendymott's Avatar
 
Join Date: Jun 2013
Location: Huddersfield, West Yorkshire, UK.
Posts: 1,782
Default CAD PCB Software

Hi Peeps, continuing on the PCB thread....has anyone got or used "EasyPC" software ? At present I have That "Wizard 3"... which in my opinion is only good for schematics. I also use DIPTRACE for pcb designs, but it has serious short comings.....and before I splash the cash on "EasyPC" I wondered if any of our members has experience of it.
I used to use Protel and Tango, both of which were excellent, but both DOS Based, and I could not get them to work satisfactorily on my PC either using Win XP or Win 7. And my PC will not run older versions of windows that have a DOS shell. The other problem was that there are no laser drivers in those packages.
So... who has EasyPC.......and... is the basic component library good enough for general use. I don't want to buy extension packages.
Over to you....
__________________
Should get out more.

Regards
Wendy G8BZY
Wendymott is offline