Thanks for the reply.
The schematic i'm using is the one refered on post #12.
I don't know if the cap in question is bad i just tought that as it seemed to be a electrolytic it would be bether to replace it all together but now that i know it's not perhaps it's ok.
But there are other problems, there are signs of previous repairs or attempted repairs,
R31 seems to have been replaced with other one it measures 28ohm
R32 NTC is all burned up and measures 380Kohm (what type of NTC can be used ?)
C39 (on the schematic it reads 22K, is it a resistor
?? ) it has a 30k resistor charred looking
There is also a 1Mohm resistor across the mains in pararell with C45 that is not on the schematic.
The mains entry area looks a mess, rest of the unit seems untouched, also as mentioned on post #11 the set voltage is 220v but the mains now is 240v i gather that even if the set is ok running it at 240v would be a bad thing ?