Quote:
Originally Posted by peter_scott
...
EHT is certainly on the low side. What tapping are you using and what supply voltage are you using?
Peter
|
Its hard to see the tap setting as its soldered in under the chassis.
I think its 250, but that might be the wire to the EHT fuse.
I have my stepup transformer set so that at our usual voltage the
filaments are 4.00 and the B+ is 280. The brightness is limited by blooming,
which of course would be helped by more EHT. Running ac up
so filaments are 4.4 makes not enough difference to matter.