Quote:
Originally Posted by G6ONEDave
That black dust could be soot from an open coal fire. If it is then I would vacuum it out, you might need to use a small paint brush to help free the dust. Remember to wear a dust mask as you don't want to breathe in the dust.
The dust if carbon based can conduct and could also cause some odd faults within the set.
Dave
|
Not sure it's coal dust, it's not too heavy a coating and even where it appears to be lots doesn't leave much of a mark on the fingers. Good point on hovering it up though. Might give that a go and see if it helps, really though I suspect I need to clear the nvm back to a default state but so far I've not been able to.