View Single Post
Old 26th May 2021, 9:09 am   #12
nzoomed
Pentode
 
Join Date: Feb 2016
Location: Tauranga, New Zealand
Posts: 118
Default Re: Advice on this linestage build

Quote:
Originally Posted by Diabolical Artificer View Post
Quote:
I know both the EF80 and EF184 are popular tubes with builders.
Mainly cos the EF80 is cheap and the EF184 cos it's mentioned quite often in thread's. The 184 comes up a lot I think cos it was used in a lot of scope front ends, it's also developed a self perpetuating self affirmation cult due to all the threads on it, not to say it's a "bad" valve.

That tone control circuit you attached is touchy, as regards gain as Robert says, I tried modding it using an ECF82 after the tone control to get extra gain in one valve base, no go. As per the author's schematic it works, mess with the gain and it's essentially an attenuator. In my case I added an ECC82 gain stage, 47k Ra, 1m grid leak. 1k ish Rk after the published circuit. You could use a CCDA line stage though.

Andy.
OK, well I may just end up going with the schematic as it is.
Will adding balance controls or a tone bypass affect anything?

I was hoping to make use of the EF86 in my build just for the sake I have so many of the things.

If anyone has any similar schematics to share, that would be great.
nzoomed is offline   Reply With Quote