UK Vintage Radio Repair and Restoration Discussion Forum - View Single Post - Garrard 401

electronpusher · 3rd May 2008, 8:09 am

I have just joined the forum and have been reading the above thread. If I can chip in my two pen'orth, I have Garrard 301 and I made a concrete base / plinth for it. I made a mould based on the plinth cut out drawings. The "concrete" used a higher than usual ratio of cement and the ballast was grit rather than small stones. It is very successful.
I painted it to look like granite.

3rd May 2008, 8:09 am	#20
electronpusher Retired Dormant Member Join Date: May 2008 Location: Norwich Posts: 1	Re: Garrard 401 - pointers for restoration I have just joined the forum and have been reading the above thread. If I can chip in my two pen'orth, I have Garrard 301 and I made a concrete base / plinth for it. I made a mould based on the plinth cut out drawings. The "concrete" used a higher than usual ratio of cement and the ballast was grit rather than small stones. It is very successful. I painted it to look like granite.