Quote:
Originally Posted by JaySpark
Hi Mike
Many thanks and also for the correction on Sectric!
|
You're welcome!
Quote:
I think I’ll strip it completely, wash all parts, apart from the motor as you suggest. Them reassemble with oiling the pivot points with a tiny drop of engine oil on each and some sewing machine on the rotor pivot as you say.
Can I ask, is sewing machine oil better than clock oil for the rotor on this type of clock?
|
Yes. Clock oil is made so it doesn't "run" - i.e. it needs to stay in the same place, whereas the rotor in a clock needs oil that can reach all parts of the bronze bearing and many of these are sintered - the bronze is made from a powder and acts a bit like a sponge.
Thanks, Paul, for the accolade!
Expert definition
Ex = has been.
Spurt = drip under pressure.