Farnell 30/10S Power Supply - Help
Hi
Some time ago I purchased second hand Farnell 30/10S power supply. I thought about using this as a good 24V bench power supply for my Clansman Radios
The unit I have has been modified to give a nominal 12V output which can be adjusted slightly.
On inspection the voltage control board has been modified, one resistor replace and another partially removed. I have tried with these back in place and the output was a fixed 21.8V and could not be adjusted.
Has anyone any experience of this power supply and is there a circuit diagram/manual available (I could not fond one on the internet)
Any help would be very much appreciated
Richard
|