Re: Hedghog standards converter
Lloyd,
The holes will be masked by the front text paper/plate, so don't worry.
I printed a front panel (as made made Frank) cut it along the lines and attached it with tape to the plastic front part, after which I punched where the holes should come, and drilled them carefully. You can always file them a bit larger if required, or in your case extend the holes to where they should be.
Check that your printed front-paper is size-accurate. A "better" printer was way off, so I used my normal printer for it.
For the back I made an alternative, since I added an RCA connector, switch, a 2-pin mains inlet and mains switch, and the shaft of a small volume control protrudes (to be able to adjust the volume - not all sources supply the same level). And a hole to be able to set VR2 when the case is closed.
Hope this helps a bit.
Jac
|