View Single Post
Old 20th Jan 2019, 10:12 pm   #4
Studio263
Octode
 
Studio263's Avatar
 
Join Date: Apr 2007
Location: Hampshire, UK.
Posts: 1,574
Default Re: A new door for a B&O Beosystem 10

Two (fairly obvious) screws inside the battery compartment, lift the bottom of the rear cover away and slide it down. Be careful though as there are quite a few little plugs to disconnect just after that.

You will struggle from there on in though as to do anything much else you have to disconnect the cord drives for both the tuning and the volume controls, this is essential before attempting to remove the main PCB. There are holes in the PCB for doing this but it isn't easy, then there's the challenge of getting them back on in the right place once you've finished...
Studio263 is offline