UK Vintage Radio Repair and Restoration Discussion Forum - View Single Post

G8UWM-MildMartin · 15th Feb 2013, 9:16 pm

Yes, I finally got round to ordering 30 of Mike Rowe's original design this week.
This time they'll be machine-drilled all holes 0.7-0.8mm and HASL tinned, but again all 3 on one platen, no solder resist nor screen printing. They should be ready in a couple of weeks. (Total cost was £243.60, so £8.12 each plus postage.)

15th Feb 2013, 9:16 pm	#772
G8UWM-MildMartin Heptode Join Date: Jan 2004 Location: Stockport, Greater Manchester, UK. Posts: 827	Re: The "Sussex" Homebrew Valve Tester. Yes, I finally got round to ordering 30 of Mike Rowe's original design this week. This time they'll be machine-drilled all holes 0.7-0.8mm and HASL tinned, but again all 3 on one platen, no solder resist nor screen printing. They should be ready in a couple of weeks. (Total cost was £243.60, so £8.12 each plus postage.)