UK Vintage Radio Repair and Restoration Discussion Forum - View Single Post

Uncle Bulgaria · 27th Jul 2019, 10:31 am

I'm not convinced the DMM is all it should be, as I've put the BD241 back in after the junctions were OK on my AVO 4.

I was looking at that as it's the first sizeable component in the PSU path and instrumental in getting an output, but now with the PSU board unsoldered from the motherboard I'm getting 9.5V.

I'm not going to be defeated having got so far, I just hoped to be putting it back together now.

On with the diagnosis with my new-found skills.

27th Jul 2019, 10:31 am	#44
Uncle Bulgaria Nonode Join Date: May 2016 Location: Cornwall, UK. Posts: 2,329	Re: Uher CR240 Troubleshooting Best Practice I'm not convinced the DMM is all it should be, as I've put the BD241 back in after the junctions were OK on my AVO 4. I was looking at that as it's the first sizeable component in the PSU path and instrumental in getting an output, but now with the PSU board unsoldered from the motherboard I'm getting 9.5V. I'm not going to be defeated having got so far, I just hoped to be putting it back together now. On with the diagnosis with my new-found skills.