UK Vintage Radio Repair and Restoration Discussion Forum - View Single Post

Timbucus · 29th May 2020, 10:51 pm

Good idea on the pulldown - I will have to buy some SMD - not something I use - maybe I can scavenge one off that board I got the Power connector from.

All those just return 0x1F now not ghosts so that seems to be working.

I did notice the RST was going to adapt my programmer to use it rather than the clips on the Cap - struggling to get that to work as is at the moment though. After a RESET it does not seem to enter the address to load at - maybe I am trying old HEX files.

29th May 2020, 10:51 pm	#456
Timbucus Octode Join Date: Mar 2019 Location: Barry, Vale of Glamorgan, Wales, UK. Posts: 1,363	Re: MK14 schematic revisions Good idea on the pulldown - I will have to buy some SMD - not something I use - maybe I can scavenge one off that board I got the Power connector from. All those just return 0x1F now not ghosts so that seems to be working. I did notice the RST was going to adapt my programmer to use it rather than the clips on the Cap - struggling to get that to work as is at the moment though. After a RESET it does not seem to enter the address to load at - maybe I am trying old HEX files.