UK Vintage Radio Repair and Restoration Discussion Forum - View Single Post - Racal-Dana 3101

PETERg0rsq · 28th Jul 2017, 8:38 pm

You need to also remove the two aluminum "ears" or feet on the back. One or two posi-drive screws in each, deeply recessed.

Once this is done the covers will slide backwards to be removed.

If you mean a panel below this, then sorry I have not got one of my 9087's open at moment to look!

With an error 80 check the reference oscillator is running from ref out socket on back.

Lots of other possible reasons for this error, but try this first.

Service manuals virtually unobtainable, and certainly no component level documents.

However very similar to 9087 generator, and limited documents available.

Certainly will be a challenge to repair

28th Jul 2017, 8:38 pm	#2
PETERg0rsq Heptode Join Date: Jun 2009 Location: St Helens, Lancashire, UK. Posts: 641	Re: Racal-Dana 3101 You need to also remove the two aluminum "ears" or feet on the back. One or two posi-drive screws in each, deeply recessed. Once this is done the covers will slide backwards to be removed. If you mean a panel below this, then sorry I have not got one of my 9087's open at moment to look! With an error 80 check the reference oscillator is running from ref out socket on back. Lots of other possible reasons for this error, but try this first. Service manuals virtually unobtainable, and certainly no component level documents. However very similar to 9087 generator, and limited documents available. Certainly will be a challenge to repair __________________ SPECIALIST.....Knows everything about nothing EXPERT..........Knows nothing about everything Last edited by PETERg0rsq; 28th Jul 2017 at 8:48 pm.