UK Vintage Radio Repair and Restoration Discussion Forum - View Single Post - Icom IC-H10

SiriusHardware · 18th Jun 2022, 9:34 pm

Hello Allan, I have this but you will need a computer which can run DOS and has a real serial com port. Windows computers up to Win 98SE had a 'DOS Prompt' terminal which I think the software will happily run in so if you have a DOS/Win 3.1, Windows 95 or Windows 98 machine handy then you should be OK.

If you don't have the means to run DOS software you can send me ONE of your H10 radio bodies and I can programme it to your requirements and you can then clone that reprogrammed radio to all of the others with a simple 2.5mm to 2.5mm stereo 'crossover' cable.

Unfortunately this would have to wait a little while as I am away from base camp for a week or so and that's where the software is.

Have you looked to see if CHIRP (popular, free, radio programming software) supports the Icom H10?

18th Jun 2022, 9:34 pm	#2
SiriusHardware Dekatron Join Date: Aug 2011 Location: Newcastle, Tyne and Wear, UK. Posts: 11,560	Re: Icom IC-H10 Hello Allan, I have this but you will need a computer which can run DOS and has a real serial com port. Windows computers up to Win 98SE had a 'DOS Prompt' terminal which I think the software will happily run in so if you have a DOS/Win 3.1, Windows 95 or Windows 98 machine handy then you should be OK. If you don't have the means to run DOS software you can send me ONE of your H10 radio bodies and I can programme it to your requirements and you can then clone that reprogrammed radio to all of the others with a simple 2.5mm to 2.5mm stereo 'crossover' cable. Unfortunately this would have to wait a little while as I am away from base camp for a week or so and that's where the software is. Have you looked to see if CHIRP (popular, free, radio programming software) supports the Icom H10?