Re: Bush DAC90A - power but no sound
If you check the primary of the output transformer, make sure you use the low ohms setting on the meter. With luck you should measure about 500 ohms give or take 50 ohms or so. If it's much above 600 ohms you MAY have a problem. If there is no reading then you DO have a problem but it is not insurmountable. Using the low ohms range across the primary should produce a crackle from the speaker IF the transformer is good. As has been said, Ed Dinning does an excellent job of rewinding these.
__________________
There are lots of brilliant keyboard players and then there is Rick Wakeman.....
|