I sould have said, on the server side is see the following:
Code:
Trace tty : Baudrate requested 9600 set 9600
Trace tty : Modem control RTS:1 DTR:1
bvrnet file server running - use t-net on the clients to connect
Trace tty < 00:00
Trace tty > 00:00
The two final trace messages appear when I issue the T-NET N command on the Gemini.
My Configuration is:
Code:
#XBEAVER network server configuration file
#Define as a server file - eg no main processor activity
cpuclock 0
# baud *tracing* *ttyport* *********************** Directories to serve ******************************************
board 0x00 serial_extloop 9600 trace tty tty /dev/ttyS0 bvrnet ./NetworkDrive
echo
echo bvrnet file server running - use t-net on the clients to connect