View Single Post
Old 31st Dec 2018, 5:36 pm   #1
Beardyman
Hexode
 
Beardyman's Avatar
 
Join Date: Jan 2018
Location: Portsmouth, Hampshire, UK.
Posts: 421
Default PYE 47X (AKA Invicta 200B)

I felt I needed something to keep me "out of trouble" over the Christmas break so I purchased a little PYE47X bakelite radio that appeared in a local charity shop for the princely sum of £7.50. It looked a wee bit sad for itself but the case was (under all the grime) intact. The plastic window had become loose & was almost opaque, oddly yellow but that was our old friend cigarette smoke/kitchen fumes. It had obviously been repaired at some point in the past but a long time ago. All the waxy's over 0.1uF were leaky/blown up. Most of the resistors were way out of their 20% tolerance as well, oddly there were two 1M's that were 'intermittent', out of circuit they would measure about 1M but if their leads were stressed this figure would drop to about 200K! Most odd. The valve line up was standard apart from the output valve, this was supposed to be a 35L6GT, in this one there was a 50L6GT, same valve but different filament voltage. After the usual clearing out of the accumulated dust/dirt/spider remains & cobwebs it was looking fairly ok. This set differs from most in that it uses inductive tuning & reflex IF rather than capacitive to receive different stations, quite a novelty in some ways. After application of switch cleaner to the volume pot & wave change switch it was time to apply some power. This, for me at least, is always a nerve wracking moment! It doesn't seem to matter how many times I check I ALWAYS check again, just to make sure. As this is an AC/DC set I decided to use the lamp limiter, all appeared well initially. After about 30 seconds or so there was a feint sign of noise from the speaker, with an aerial attached it successfully pulled in a few local MW stations. Then I notices smoke! Heck! Where was that coming from? And why did it smell of talcum powder?!? It was, of course, the dropper burning off years of accumulated dust & moisture. Over several cooling/heating cycles this has now stopped but that dropper gets mighty hot. As to where the set will go now I have no idea, no doubt a place will show itself, eventually.........
Attached Thumbnails
Click image for larger version

Name:	DSC_0206.jpg
Views:	228
Size:	73.1 KB
ID:	175500   Click image for larger version

Name:	DSC_0209.jpg
Views:	203
Size:	89.3 KB
ID:	175501   Click image for larger version

Name:	DSC_0240.jpg
Views:	193
Size:	80.4 KB
ID:	175502   Click image for larger version

Name:	DSC_0243.jpg
Views:	208
Size:	97.6 KB
ID:	175503   Click image for larger version

Name:	DSC_0244.jpg
Views:	193
Size:	72.5 KB
ID:	175504  

__________________
The difference between stupidity and genius is that genius has its limits. (Einstein)
Beardyman is offline