View Single Post
Old 6th Jun 2021, 1:00 pm   #23
Nanozeugma's Avatar
Join Date: Nov 2017
Location: London, UK. North Manchester now and then :)
Posts: 477
Default Re: Enlarging an existing hole in a steel chassis.

Just to put this one to bed, and thanking all contributors for their thoughts and experiences.... I did eventually purchase a cone drill set - but decided against using it in case it "grabbed" at the metal and distorted the hole.
In the end, I placed a card template over each hole to define the new diameter required and reamed the hole out gradually with an abrasive drum on my Dremel. Worked quite satisfactorily.
Thread may be closed at Mod discretion.
Thermionic Emission, cures depression, boredom and piles.
Nanozeugma is offline