Re: Non-working Commodore PET 3016
That's useful to have confirmed but I did say earlier that it was not necessary to make the measurements in #203 and #206 - a bit of brain-fade on my part, I thought you had measured a low voltage on RDY, not the high voltage you actually measured.
Focus now on using your scope to look first at the 1MHz output on UG5 pin 7 (which we are sure is there, so it's a good practice target) and then move to 6502 pins 9, 10, 11 (at least) to see if you have any activity on those pins.
|