UK Vintage Radio Repair and Restoration Discussion Forum - View Single Post - BBC Microcomputer/Commodore schematic or PCB design software?

Philips210 · 10th Sep 2018, 9:21 pm

Thanks for clarifying that Dave. I seem to remember sideways RAM is fitted. There was a toggle switch that was operated and remember typing *PCB to load the Pineapple software. It's all a long time ago so I am looking forward to setting up my old system again which was last used in the mid 1990s. I'll first check out the PSU and look to see if there is a Rifa X type cap fitted to prevent any unnecessary drama.

Regards
Symon

10th Sep 2018, 9:21 pm	#11
Philips210 Nonode Join Date: May 2007 Location: Redruth, Cornwall, UK. Posts: 2,573	Re: BBC Microcomputer/Commodore schematic or PCB design software? Thanks for clarifying that Dave. I seem to remember sideways RAM is fitted. There was a toggle switch that was operated and remember typing *PCB to load the Pineapple software. It's all a long time ago so I am looking forward to setting up my old system again which was last used in the mid 1990s. I'll first check out the PSU and look to see if there is a Rifa X type cap fitted to prevent any unnecessary drama. Regards Symon