View Single Post
Old 8th Mar 2006, 6:25 am   #3
Stewart
Hexode
 
Stewart's Avatar
 
Join Date: Jul 2003
Location: N.E. Surrey, UK.
Posts: 361
Default Re: Low hum on a Bush VHF64

I had this exact same problem on one of my VHF64s - and as Setappeal says it was due to chassis members not making good contact with each other. I found this out by connecting a probe to the negative of the main electrolytic and moving around the various points that should be "grounded". An resistance check failed to reveal the problem - but this method did! If I remember correctly it was one of the side chassis panels that was not making good contact - even though it looked clean and secure.

Once attended to the set runs alomost silently! Good luck!

Stewart
Stewart is offline