UK Vintage Radio Repair and Restoration Discussion Forum - View Single Post

Andrew Wyard · 23rd Jun 2021, 3:25 pm

Hi, just a quick reply.

I'm not going to get near this again until next week!

As for the test equipment. It's a Tektronix 454 which is quoted on certain ranges to go up to 150MHz. The probe might be a different story. It's not an original Tek item, I will do some checking to make sure I'm not being taken for a ride. I was using another probe which gave similar results, but it would be good to rule them out.

Thanks for the comments. Andrew.

23rd Jun 2021, 3:25 pm	#12
Andrew Wyard Diode Join Date: Mar 2021 Location: Bracknell, Berkshire, UK Posts: 4	Re: Advance E2 Signal Generator fault Hi, just a quick reply. I'm not going to get near this again until next week! As for the test equipment. It's a Tektronix 454 which is quoted on certain ranges to go up to 150MHz. The probe might be a different story. It's not an original Tek item, I will do some checking to make sure I'm not being taken for a ride. I was using another probe which gave similar results, but it would be good to rule them out. Thanks for the comments. Andrew.