Re: Frequency counters
Problem with doing that, I don't have a 50 ohm terminator as yet, I just learning my way around again after many years away from electronics. How I measured it was by using the standard 100Mhz probes clipped directly onto the output terminations of the generator by removing the screw clamps so the ground clip was connected directly to the ground and the probe tip just inserted inside the banana socket on the high out socket. So the only lead, coax or other was the probe lead itself.
Is that not the best method then? Sorry if I might seem to be a little slow on these things, it was around 50 years ago when I was playing around with electronics, so I have a lot to catch up on and re-learn as I go.
|