Re: Reel tape retainers
I have used "SUGRU", a new rubber type adhesive that I found on Ebay.
1. Roll a lump of SUGRU into a ball approximately 5mm dia.
2. Squash the ball to the size of a 10p piece.
3. Place it centrally across the hole in the retainer.
4. Knead the Sugru into the surface of the retainer around the hole.
5. With the point of a pencil, create a hole in the Sugru slightly smaller than the original retainer hole - knead the excess Sugru (that forming the hole has created) into the retainer to leave a contour similar to the original underside of the retainer.
6. Leave for 24 hours.
Voila!
|