Re: 819 line standards convertor.
Hi dominicbeesley,
What kind of FPGA kit did you have?
Mine is a FPGA kit from Digilent.
It's an NEXYS2 with a SPARTAN 3E and 500K gates.
For the converter, I thing you can use less than 500K gates.
In fact, you need at least in the FPGA to have around 8 KBytes of RAM.
=> 4 KBytes per FIFO => there is 2 FIFO working in paralel.
Then you add TDA8708, TDA 8702 and a EL4583( synchro extractor).
Don't forget to put to all signal a resistor between 100 ohms to 470 ohms to avaoid frying your FPGA ( Only 3v Tolerant...).
If you want my final code, I can supply it to you.
The same for the schematic.
Fred C.( Pitbuell94).
|