Re: Uher CR 210 Cassette Recorder Check Out
After quite a struggle got the motor dis-assembled, the 2 brass pulleys were not keen to come off the motor shaft at all. Needed heat and leverage, think a very tight interférence fit, not looking forward to refitting the pulleys.
Found 2 of the 3 sprung contacts are stiff and feel graunchy when contact moved against its spring, hopefully with a good clean these will improve. The third contact is free to move, but its centrifugal weight fouls (stopping the contact full range of motion against its spring) a brass circular disc that sits on the motor shaft behind the contacts assembly. The disc was tilted over, I have now re-aligned it and the contact now does not foul.
The 3 segment copper contact plate that the 3 contacts make contact with needs a good clean.
David
|