View Single Post
Old 18th Jun 2018, 5:44 pm   #9
usradcoll1
Heptode
 
Join Date: Mar 2017
Location: Cedar Grove, Wisconsin, USA.
Posts: 823
Default Re: Workshop dig out

Quote:
Originally Posted by G4_Pete View Post
This is my workshop under the stairs that had fallen into a junk storage area and not been used for a few years. So today decided to restore it to use. Found a fully restored VHF 71 , forgot I did it and had to do a cap check before powering!! All caps were new. Also found bits of test gear that I had not seen for ages. I eventually got it all cleared and gradually tested things. The only failure was my faithfull Maplin frequency counter that worked for a few mins then wouuld not respond to the selection buttons.
Note there is an extraction fan under the shelf overhang to take out fumes should I solder under the overhang.
Cross connected everything in Dr Who fasion with a lissajous for the final photo.

The challenge now is to keep it tidy and useable.

Pete
Your last statement about tidy and useable was one challenge I was never able to master.
That trait seems to be universal in a hobby of this type.
usradcoll1 is offline