UK Vintage Radio Repair and Restoration Discussion Forum - View Single Post

Refugee · 24th May 2018, 12:40 pm

The bits I was given were a couple of prototype units with a later circuit diagram with the head amp shown as a block. I can't remember if I have a circuit diagram for the head amp but I do have a couple of broken ones and quite a few boards that were production rejects.
The bits I am short of are lens mounting brackets and scan coils.
I have three sets of working boards with scan coils and only one good scan coil to lens mount. I could use a dead chassis with a C-mount thread on it.

24th May 2018, 12:40 pm	#16
Refugee Dekatron Join Date: Apr 2012 Location: Worksop, Nottinghamshire, UK. Posts: 5,554	Re: Head amp for a vidicon The bits I was given were a couple of prototype units with a later circuit diagram with the head amp shown as a block. I can't remember if I have a circuit diagram for the head amp but I do have a couple of broken ones and quite a few boards that were production rejects. The bits I am short of are lens mounting brackets and scan coils. I have three sets of working boards with scan coils and only one good scan coil to lens mount. I could use a dead chassis with a C-mount thread on it.