View Single Post
Old 30th Sep 2019, 9:11 am   #4
RestorationRod
Triode
 
Join Date: Feb 2018
Location: Reading, Berkshire, UK.
Posts: 16
Default Re: EKCO TP-308 restoration

I have the full set of circuits and service notes. All components have been checked for the correct value ( I have good H-P in circuit L-C-R tester) and replaced if out of spec. Pots are paxolin or similar and look flimsy. Knobs are integral to the pots and held on with a spire fastener. Very nasty!!. Any old pots that get changed (the vol/on-off already has) will have their knobs cut off and be drilled for 6mm (1/4") shafts and put on the new ones.
RestorationRod is offline