Re: Advance E2 with problems.
Thanks to everybody for the input and such useful information.
I have to correct the valve used for the oscillator. I said it was an ECC82, having looked at the circuit. In fact the valve in my unit is an ECC91 this being intended for VHF .
I have 5 copies of the service information 2 stating ECC82, whilst the other 3 are not readable well enough to be sure what they say.
The ECC91 I have just tested again the result being Ma/v 5.4 and 5.7. Data sheet gives 5.3.
I do have a spare ECC91 but it is much the same at Ma/v of 5.1 and 5.2, little point in changing it.
I will run another set of tests, this time using the attenuator in circuit and see what happens.
Also I am thinking of making an adaptor to be able to plug into the 7 pin base an ECC81, maybe.
Best regards,
Dave.
|