Vintage sewing machine suppressor help!
Hi.
I bought a vintage Singer 401 (i think) sewing machine for cheap as this came without foot controller. However I happened to have a modern one which I had got to fit my vintage Singer 99k.
I used the foot controller at the seller's house with no issues, so I purchased the machine. I brought it home and cleaned and oiled it up. I put the foot controller back in to try out the machine, and the machine was really struggling to go. It then went pop and a puff of smoke near the motor. I took it apart and it looks like the Interference Suppressor has gone on it. I thought oh that's fine I will pop down to the electrical shop and see if they have a replacement, but I was soon told this part is not a thing they have, nor did they have an equivalent part, nor make anything like this...
Now I am not electrically minded AT ALL, so I am really struggling to find any information on this part, whether I can buy a part like this or even any kind of equivalent thing that will do the same job.
I would love to be able to get this sewing machine going again, so any information on if it's fixable would be greatly appreciated! However there will be a cost where it would just not be feasible.
I have attached photos of the part, which I hope will help.
Thank you immensely.
|