UK Vintage Radio Repair and Restoration Discussion Forum - View Single Post

Lloyd 1985 · 10th Feb 2019, 6:38 pm

I’ve made a start on my 2, so far so good! I’ve put all except 2 values of resistor down, as I didn’t have them, and started on the caps. More stuff arriving tomorrow hopefully, from Mouser, I got the rest of the caps and some of the silicon from them, I’ve only ordered 1 FPGA so far, and it won’t even be posted until after the 14th, all the Chinese eBay sellers seem to be on holiday until then! I still need to order a few bits, mainly switches, the toggles are quite pricey! I might go for alternatives from RS, since I’ll be getting the 16 position hex switches from there.

Regards
Lloyd

10th Feb 2019, 6:38 pm	#30
Lloyd 1985 Nonode Join Date: Jun 2008 Location: Coningsby, Lincolnshire, UK. Posts: 2,819	Re: Hedghog standards converter I’ve made a start on my 2, so far so good! I’ve put all except 2 values of resistor down, as I didn’t have them, and started on the caps. More stuff arriving tomorrow hopefully, from Mouser, I got the rest of the caps and some of the silicon from them, I’ve only ordered 1 FPGA so far, and it won’t even be posted until after the 14th, all the Chinese eBay sellers seem to be on holiday until then! I still need to order a few bits, mainly switches, the toggles are quite pricey! I might go for alternatives from RS, since I’ll be getting the 16 position hex switches from there. Regards Lloyd