Re: GEC BC5050 receiver.
Looks like I misunderstood this (my emdoldening) : -
"With all the valves in place, connect the test meter between the live and neutral wires of the mains flex. Operate the power switch on the set and note the resistance reading ... For an AC only set using a mains transformer it will be a couple of hundred ohms (the exact figure will be on the service sheet). Anywhere around this area is OK for now. If it is very low (tens of ohms) or short circuit, you have a problem that needs further investigation and correcting before power is applied. "
__________________
BVWS Member
|