UK Vintage Radio Repair and Restoration Discussion Forum - View Single Post

Slothie · 30th Jul 2021, 7:18 pm

Yes, I was only intending to show how to wire from connector to connector, if people have a JMP and want to make a plug arrangement then they'll have to hack the PCB appropriately. Again, a V2 PCB would probably take this into account, since presumably there are a number of JMP owners out there.

I presume the change of mapping of the GPIO pins could be done in software.

30th Jul 2021, 7:18 pm	#37
Slothie Octode Join Date: Apr 2018 Location: Newbury, Berkshire, UK. Posts: 1,287	Re: MK14 Programming Interface Yes, I was only intending to show how to wire from connector to connector, if people have a JMP and want to make a plug arrangement then they'll have to hack the PCB appropriately. Again, a V2 PCB would probably take this into account, since presumably there are a number of JMP owners out there. I presume the change of mapping of the GPIO pins could be done in software. Last edited by Slothie; 30th Jul 2021 at 7:21 pm. Reason: Mapping