[QUOTE=ms660;1375059]
Quote:
Originally Posted by ms660
Quote:
Originally Posted by reartech
No sir dont get confusion to trace the problem I reversed the unit and in this stage i cant play tape due to gravity spool tape will fall down hence i connected BT there is no issue with machanisum it is ok
|
Which is basically what I was implying.
Could you feed your signal in again at the junction of contacts D1 and D4 (the input to C13) with the control set to Playback and report back with the result.
Lawrence. |
Yes sir you are cached my point I given BT input to c13 directly now think that d1 is on audio is very low and if push d4 same signal audio is in full volume then i am not in a position to trace out what happens while d4 released audio became very low with same setting
Please guide me is my logic is correct