Re: Commodore PET 2001 voltage regulators
Hi.
Okay, I took a few measurements over different periods of time and they all seemed to be around the same value. The last two sets I have are as follows:
CR1 = 9.04/3v
CR2 = 9.04/3v
JP8 pin 4 = 9.04v
CR1 = 9.08v
CR2 = 9.06v
JP8 pin 4 = 9.07v
These readings were taken when the PET was first switched on, then after running for a few minutes. I did check CR1 a few times, and if this changed, then I checked pin 4 - they were about in sync value wise from what I could see.
|