UK Vintage Radio Repair and Restoration Discussion Forum - View Single Post - Kolster-Brandes MR10

crackle · 9th Sep 2019, 3:38 pm

Have you got the KB service manual from my web site, have a look at page 8, this should cover the version you have.
The anode resistor for the V2 6U8 (ECF82 in your case) pentode section is shown as 47K, By the way all the voltages on that circuit diagram are what I actually measured on my radio, I added them to the schematic just as a reference point.
I tend to not worry too much about resistors at this stage, until after I have replaced all the horrible hunts. Then change what's required after checking the voltages.

Mike

9th Sep 2019, 3:38 pm	#31
crackle Rest in Peace Join Date: Mar 2011 Location: Basildon, Essex, UK. Posts: 4,100	Re: Kolster-Brandes MR10 Have you got the KB service manual from my web site, have a look at page 8, this should cover the version you have. The anode resistor for the V2 6U8 (ECF82 in your case) pentode section is shown as 47K, By the way all the voltages on that circuit diagram are what I actually measured on my radio, I added them to the schematic just as a reference point. I tend to not worry too much about resistors at this stage, until after I have replaced all the horrible hunts. Then change what's required after checking the voltages. Mike