UK Vintage Radio Repair and Restoration Discussion Forum - View Single Post

Station X · 1st Oct 2020, 8:20 pm

I had assumed that the OP's problem was deep drilling into the fins, the holes in the thin part of the heat sink being drilled right through.

I'll find out when I get the job and can use channel or W.H.Y if necessary.

1st Oct 2020, 8:20 pm	#10
Station X Moderator Join Date: Jan 2003 Location: Ipswich, Suffolk, IP4, UK. Posts: 21,288	Re: Drilling large finned heatsink I had assumed that the OP's problem was deep drilling into the fins, the holes in the thin part of the heat sink being drilled right through. I'll find out when I get the job and can use channel or W.H.Y if necessary. __________________ Graham. Forum Moderator Reach for your meter before you reach for your soldering iron.