Quote:
Originally Posted by Radio Scotland
Quote:
Originally Posted by ms660
The voltages in the schematic for the output transistors were measured WRT B+ve because the transistors are PNP types, it makes it easier to interpret for those types.
The voltages for the other transistors were measured WRT B-ve because those transistors are NPN, again it makes it easier to interpret for those types.
Lawrence.
|
Cheers Lawrence. But I think I've finally figured it out, See my above post.
Cheers
Jay |
Yes but if your measurement of 9 volts on the emitters was WRT B+ it means 9 volts across R26...
Lawrence.