Quote:
Originally Posted by DMcMahon
Still have the very original issue of the HT voltage being too high. The value of 332 V above is 47V higher than stated value on schematic and no obvious reason found. The AC voltage across the EZ 80 full wave rectifying valve anodes is 615V which is 45V higher than stated value on schematic.
I know the values shown on the schematic are approximate but my values do seem just too high to me.
|
Contemporary Grundig manuals give voltages as read by an Avo 7, and it is likely that Brenell specify something similar. A modern meter is going to give a higher reading as it will load the circuit less.