UK Vintage Radio Repair and Restoration Discussion Forum - View Single Post - Drilling holes to clean vol control's etc

paulsherwin · 31st May 2020, 9:59 pm

I've always been a bit wary about doing this precisely because of the swarf issue, but on the few occasions I've had to do it there haven't been any problems.

31st May 2020, 9:59 pm	#9
paulsherwin Moderator Join Date: Jun 2003 Location: Oxford, UK Posts: 27,947	Re: Drilling holes to clean vol control's etc I've always been a bit wary about doing this precisely because of the swarf issue, but on the few occasions I've had to do it there haven't been any problems.