UK Vintage Radio Repair and Restoration Discussion Forum - View Single Post

ms660 · 16th Jun 2019, 8:34 pm

That part of the layout in the photo's looks very similar to the layout shown in the Ace Crescendo service sheet (Trader)

If one end of that disconnected black wire is connected to chassis it's possible that the disconnected end might have been soldered to the body of the tone pot, it looks as though the bottom end resistor in the tone circuit (connected to the right hand tag of the pot in the 2nd photo) might also be soldered to the pots body?

Lawrence.

16th Jun 2019, 8:34 pm	#5
ms660 Dekatron Join Date: Apr 2011 Location: Cornwall, UK. Posts: 13,454	Re: Ace Embassy 50 That part of the layout in the photo's looks very similar to the layout shown in the Ace Crescendo service sheet (Trader) If one end of that disconnected black wire is connected to chassis it's possible that the disconnected end might have been soldered to the body of the tone pot, it looks as though the bottom end resistor in the tone circuit (connected to the right hand tag of the pot in the 2nd photo) might also be soldered to the pots body? Lawrence.