[Darrencambs]

Morning all,

Been a bit busy at work these last few weeks, but have made a small amount of progress on this project. Lamp limiter is built and I've knocked up a jig to hold the radiogram chassis.

I've attached a copy of the service manual (from a Granada 23400) and made a visual check of all the wax capacitors. All look OK with none showing any obvious signs of problems.

However, some of them are going to be a nightmare to get at without completely stripping the chassis down, so I'd be grateful for any opinion on which ones I should definitely replace before I start it up. I'd also welcome any recommendations as to the best brand, type and where to source the replacements from.

Thanks in anticipation!