Re: PCB production using toner transfer
Hi John
The backing paper method was used in a You Tube PCB video, so I think you are on to a winner with it. I just hope the old carpet you wiped it with wasn't in your living room - especially if it is silicone! Tread with care, perhaps? Only joking.
I don't know if lacquer would dissolve toner. It is remarkably hard to shift once it has been ironed on, but I guess lacquer spray might act as a solvent. In which case an alternative would be a covering plate of clear Perspex.
Thanks for your interest and contribution. Always good to hear from you.
Tony
|