Quote:
Originally Posted by howard
Hello Colin,
The bakelite around the front was cleaned with white spirit to remove any Nitromors and greasy finger marks and then wiped dry with a paper towel. Plasti-kote adheres to bakelite very well, indeed it's quite hard work getting any overspray off. It's essential to use Tamiya masking tape which is not paper based and it's flexible so will go around curved edges without wrinkling and afterwards comes off clean leaving no sticky residue. The tricky bits are the rounded corners, there I use several short pieces of tape. It is very expensive though and is only available from model shops.
Howard
|
Hi Howard, thanks, I did wonder if you'd used a primer but it seems not. I like the tip about the flexible Tamiya masking tape. I must get myself some!