Re: Bell and Howell TQII 1652 16mm projector
Thank you for you further comments.
I suspect that you are correct David - a shorted transistor. It's an amazingly small module. Goodness knows what's in it.
As for the reference circuit, well I think it's ok. At least I'm getting a change on voltage at pin 5 when I switch from 18 fps to 24 fps - not much though - only 0.4 Vd.c. This might be ok?
For completeness:-
U1/EXC-030/XU1 d.c. voltages (projector running, everything connected as it should be):-
Pin Volts
1 39.2
2 15.3
3 0.7
4 0
5 10.8 at 18 fps, 10.4 at 24 fps
6 9
7 9
Regards,
Andy
__________________
Now where on earth did I remove that from?
|